A2b ETX-200 Guide d'installation télécharger pdf (Page 15)

English

5 Menus and settings (continued)

5.2.a Input settings ESX-200, (continued)

Finally enter the correct Symbol rate and click on [Set] and then enter the

Transponder frequency and click on [Set]. The available services are listed to the

right.

We suggest that you consult: http://en.kingofsat.net/ or another web site for

correct parameters for the services you intend to use.

The input level should be higher than -65 dBm, preferably more than -50 dBm

and max -25 dBm and C/N should read more than 10 dB.

5.2.b Input settings, ETX-200

Select the bandwith of the

channel you want to receive.

Next select the channel number

according to CCIR or enter the

correct frequency (in MHz). Be

sure to press [Set] to enter the

frequency to the ETX-200.

A list of the available services

from the multiplex you tuned to,

will be shown on the right hand

side.

Below [Tuner settings]

information of the received

signal is displayed.

If only ”ASI in” is used you can

”Disable” the tuner at [Input

source].

We suggest that you consult

your local terrestrial operator for

correct parameters for each

multiplex you want to receive.

Note! We recommend that the

[Level] reading is between

-31dBm to -55 dBm and C/N

better than 25 dB for best

performance.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 47 48

Pas de commentaire

A2b ETX-200 Guide d'installation Page 15